≡ Menu

networking configuration

No Route to Host error and solution

I am getting error that read as No Route to Host. I am trying to ping my ISP gateway as well as DNS server but I am getting this error. How do I solve this problem?

This problem indicate networking conflicts or some sort of networking configuration problem.

Here are things to check:

Can you ping to your local router interface (such as

Make sure your card (eth0) is properly configured with correct IP address and router address. Use ifconfig command to configure IP address and route command to setup correct router address. If you prefer to use GUI tools:

  • redhat-config-network - Works on Red Hat and Fedora Linux/Cent OS.
  • network-admin - Debian and Other Linux distribution use this GUI too

Use above two GUI tools to setup correct IP address, DNS address and router address.

b) Make sure firewall is not blocking your access

iptables is default firewall on Linux. Run following command to see what iptables rules are setup:
# /sbin/iptables -L -n

You can temporary clear all iptables rules so that you can troubleshoot problem. If you are using Red Hat or Fedora Linux type command:
# /etc/init.d/iptables save
# /etc/init.d/iptables stop

If you are using other Linux distribution type following commands:
# iptables -F
# iptables -X
# iptables -t nat -F
# iptables -t nat -X
# iptables -t mangle -F
# iptables -t mangle -X

c) Finally make sure you are using a router and not a proxy server. Proxy servers are good for Internet browsing but not for other work such as ftp, sending ICMP request and so on.

See also:

HP-UX: How Do I configure routing or add route?

You can use route command to configure routing. Syntax is as follows:
route add net {network-address} netmask {subnet} {router-address}

Let us assume your router address is and network ID is, then you can type route command as follows:
# route add net netmask


To add a default route:
# route add default

Verify that (display) routing table is updated (display routing table):
# netstat -nr

Test it i.e. try to ping or send nslookup request:
# ping mycorp.com

To flush all routing entries use command [quite handy to clean your gordian knot ;)] :
# route -f

However if I reboot HPUX box then above routing entries gets removed. To pick up your setting upon each reboot your need to configure Routes in HPUX networking configuration file - /etc/rc.config.d/netconf. To add default router/gateway
# vi /etc/rc.config.d/netconf

Add or modify following entries


Reboot HP-UX system/server to take effect
# shutdown -ry 0

How Do I Run a Firewall Script As Soon As eth0 Interface Brings Up?

I use ADSL at home via ISP modem. As soon as my eth0 comes up I would like to have my firewall script get executed and setup the iptables firewall rules for me.
[click to continue…]